Voltic Amp Top Attenuator (Discontinued)
DISCONTINUED NOV 2024
Turn big sounds into little sounds with the Voltic Electronic Devices ATA.
This pedal is designed to be used in the FX loop of a non-master volume amp, such as the Fender Hot Rod and Blues series. The level pot will allow you to drive your preamp harder, while the cut switch allows you to attenuate any spike-y high end that your amp may produce.
This unit is completely passive and can use either jack as the input/output.
All Voltic Electronic Devices are handmade in Wilmington, DE. I drill and stamp every enclosure, cut every strip board, as well as, test and solder every single component.
Note: due to the hand stamped nature of our artwork, your individual pedal may not look exactly like the image shown below. Though we do strive for each pedal to look as identical as possible, invariably, some may end up with with slightly more or less detail. This is not a defect but, simply, a result of the handmade nature of the product.
DISCONTINUED NOV 2024
Turn big sounds into little sounds with the Voltic Electronic Devices ATA.
This pedal is designed to be used in the FX loop of a non-master volume amp, such as the Fender Hot Rod and Blues series. The level pot will allow you to drive your preamp harder, while the cut switch allows you to attenuate any spike-y high end that your amp may produce.
This unit is completely passive and can use either jack as the input/output.
All Voltic Electronic Devices are handmade in Wilmington, DE. I drill and stamp every enclosure, cut every strip board, as well as, test and solder every single component.
Note: due to the hand stamped nature of our artwork, your individual pedal may not look exactly like the image shown below. Though we do strive for each pedal to look as identical as possible, invariably, some may end up with with slightly more or less detail. This is not a defect but, simply, a result of the handmade nature of the product.
DISCONTINUED NOV 2024
Turn big sounds into little sounds with the Voltic Electronic Devices ATA.
This pedal is designed to be used in the FX loop of a non-master volume amp, such as the Fender Hot Rod and Blues series. The level pot will allow you to drive your preamp harder, while the cut switch allows you to attenuate any spike-y high end that your amp may produce.
This unit is completely passive and can use either jack as the input/output.
All Voltic Electronic Devices are handmade in Wilmington, DE. I drill and stamp every enclosure, cut every strip board, as well as, test and solder every single component.
Note: due to the hand stamped nature of our artwork, your individual pedal may not look exactly like the image shown below. Though we do strive for each pedal to look as identical as possible, invariably, some may end up with with slightly more or less detail. This is not a defect but, simply, a result of the handmade nature of the product.